Our Orrville crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Limestone County within days.
Written quote at no cost, one callback, no chasing afterwards.
That bulky old basin in your bathroom probably takes up way too much space and feels like a hazard every time you step over the high ledge. Actually, swapping that unused tub for a sleek walk-in stall is one of the smartest upgrades you can make for your daily routine. This fresh setup gives you instant accessibility and makes your entire bathroom look twice as big... which is a major win for your home value.
If you are tired of scrubbing those hard-to-reach corners under the faucet, you are not alone. Our team travels right to your doorstep to measure your space and give you a completely free estimate for this exciting transformation. We handle everything from the initial teardown to the final watertight seal so you do not have to lift a single finger.
Let us look at how this simple swap can change your life and make your daily routine feel like a trip to a fancy resort. You deserve a space that works for your lifestyle instead of causing a daily headache.
Think about how many times you actually soak in that deep basin compared to how often you just want a quick, refreshing wash. For most folks, the answer is almost never, which means you are wasting precious square footage on a dusty relic. By replacing that old behemoth with a modern low-profile pan, you open up the room and create a much safer environment.
Safety is a huge factor here because slipping on wet porcelain is no joke. A low-threshold entry minimize the risk of falls, making it incredibly easy for everyone in the household to get clean without any scary acrobatics. On top of that, these modern designs are a breeze to sanitize because they do not have those deep, grime-collecting crevices.
To help you compare the two options, we put together a quick breakdown of how these setups stack up against each other in daily life.
| Feature | Old Deep Basin | New Walk-In Stall |
|---|---|---|
| Entry Height | High step-over (15-20 inches) | Low-profile (1-3 inches) |
| Floor Space | Cramped and bulky | Open and spacious |
| Cleaning Effort | Back-breaking scrubbing | Quick wipe-down |
| Water Usage | High volume fill-ups | Efficient drainage |
As you can see, the benefits of making the switch are pretty clear. You get more space, better safety, and a much modern look without any of the old hassles.
When you decide to renovate, you get to choose from a ton of awesome materials that match your personal style. For instance, high-gloss acrylic surrounds are incredibly popular because they resist mold and do not require heavy scrubbing. Alternatively, you can go with gorgeous ceramic tile if you want that custom, high-end look that really wows visitors.
Adding smart accessories is another way to make the space truly yours. You can install built-in benches, sturdy grab bars, or recessed niches for your shampoos and soaps. These little touches turn a simple utility into a personalized retreat where you can wash away the stress of the day.
During our visit, we will show you physical samples so you can feel the textures and see the colors in your own lighting. This hands-on approach ensures you get exactly what you want without any guessing games.
You might be wondering how we actually pull off this magic trick without turning your home into a dusty disaster zone. First, we carefully protect your flooring and walls before we touch a single tool. Then, we gently remove the old cast iron or steel basin and inspect the underlying subfloor for any hidden water damage.
Next, our skilled crew reroutes the plumbing lines to line up perfectly with your new center or side drain. We apply premium waterproofing membranes to the studs to ensure that moisture never seeps into your walls. Finally, we install the new base, finish the gorgeous wall panels, and hook up your shiny new fixtures.
This entire process is usually completed much faster than a full remodel, meaning minimal disruption to your daily life. You will be back to using your bathroom in no time, but with a whole new level of convenience.
Homebuyers these days are actively looking for properties that feature modern, accessible wash spaces. By making this upgrade, you are actually investing in the long-term marketability of your house. This is especially true in cozy, close-knit communities where folks appreciate practical, long-lasting home improvements.
Speaking of local areas, we love serving the folks in Limestone County, where community values and honest work still mean something. Whether you live near the heart of town with its historic charm or out in the quieter spots of Orrville, Alabama, we treat your home like our own. With a local population of around 175 friendly neighbors and a median household income of $13,750, we know the importance of getting real, honest value for every hard-earned dollar you spend.
We tailor our services to fit the unique needs of homes in the 36767 ZIP code area perfectly. Our goal is to deliver top-notch craftsmanship that stands the test of time, giving you ultimate satisfaction without breaking the bank.
There is absolutely no reason to keep struggling with a bathroom layout that does not serve your needs anymore. Our friendly team of local professionals is ready to guide you through the entire process from start to finish. We pride ourselves on clear communication, punctuality, and incredibly clean work sites.
When you contact us, we will schedule a convenient time to come out, look at your current setup, and chat about your vision. We will provide a detailed, itemized quote with zero pressure and zero hidden fees so you can make an informed decision.
Take the first step toward a more beautiful, accessible, and functional home today. Simply reach out to us to request your complimentary, no-obligation estimate and let us turn your bathroom dreams into reality!
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Orrville repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Limestone County; the statewide picture lives on Alabama; the wider region is the South; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote