Our Warren City crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Gregg County within days.
Written quote at no cost, one callback, no chasing afterwards.
If you feel tired of stepping over a high porcelain barrier just to wash yourself, we can swap that bulky old basin for a sleek walk-in stall today. This simple upgrade prevents slips while giving your daily routine a fresh spark of energy. You deserve a modern wash space that fits your busy life without costing a fortune.
Maybe you remember when those deep cast-iron basins were all the rage back in the day. Nowadays, nobody actually has the time to sit and soak for hours when a quick, hot spray is what you really need. Removing that old hazard creates a spacious area where you can move freely without tripping.
Suddenly, your cramped washroom feels twice as big because we open up the floor plan. This change also eliminates those nasty mildew lines that always grow under the rim of a deep basin. You will spend way less time scrubbing on your knees, which is a massive win for your back.
Our local team specializes in pulling out those outdated tubs and installing beautiful, low-profile bases. We handle everything from the initial demolition to the final waterproof seal so you do not have to lift a finger. You get a gorgeous, functional setup that makes your morning routine feel like a trip to a fancy resort.
Think about how much safer your home becomes when you remove the main source of bathroom slips. Older folks and young kids alike struggle with high steps, which makes this upgrade a smart move for long-term safety. It is all about peace of mind for your entire family.
Besides the safety aspect, you will notice a huge bump in your property value. Most modern buyers look for walk-in stalls rather than dusty old soaking tubs they will never use. This means your investment pays off down the road if you ever decide to sell your home.
To help you visualize the transformation, here is a quick look at how the two setups compare in daily life:
| Feature | Old Deep Basin | New Walk-In Spray |
|---|---|---|
| Step-In Height | 15 to 18 inches | 3 to 5 inches |
| Cleaning Effort | High (lots of bending) | Low (easy wipe-down) |
| Water Usage | High (35+ gallons) | Low (efficient flow) |
| Visual Space | Cramped and bulky | Open and airy |
Living here in Warren City, Texas, means dealing with humid summers where a quick, cool wash is a daily necessity. Our quiet little community in Gregg County, with our tight-knit population of 362 residents, deserves top-tier home improvements. With a local median household income of $63,750, homeowners in our ZIP codes want real value for their hard-earned dollars.
First, we come out to your house to take precise measurements of your existing layout. This ensures that the new base fits perfectly into the exact footprint of your old unit. We chat about your style preferences, whether you want classic tile patterns or modern solid panels.
Next, our crew carefully extracts the old basin without damaging your surrounding walls or flooring. We check the exposed plumbing for any hidden leaks or wood rot that might cause trouble later. Fixing these issues early saves you thousands of dollars in potential water damage down the line.
After that, we install the new high-density acrylic pan and hook up the drains securely. We apply advanced waterproofing membranes behind the walls to guarantee a leak-free experience for decades. Finally, we mount your choice of sliding glass doors, handy grab bars, or built-in corner shelves.
Selecting the right wall surround determines how much maintenance you will face in the future. Acrylic panels offer a seamless look that resists mold growth and requires zero grout scrubbing. On the other hand, custom tile allows for endless design patterns if you want a unique look.
We always recommend non-porous materials because they stand up to hard water much better over time. This keeps your wash space looking brand new even after years of daily use. You get to enjoy a sparkling clean environment with just a quick spray of glass cleaner.
Installing a multi-function showerhead lets you customize your spray pattern from a gentle mist to a pulsing massage. This simple addition turns a basic wash into a relaxing ritual that melts away the stress of a long workday. Plus, modern fixtures use much less water while still delivering excellent pressure.
We can also add hand-held wands which make washing pets or cleaning the walls incredibly easy. These flexible hoses reach every corner so you do not have to splash water around manually. It is a small detail that makes a massive difference in your daily convenience.
Many homeowners worry that this project will take weeks and leave their home in a dusty mess. Fortunately, our experienced crew usually wraps up the entire swap in just a couple of days. We protect your floors with drop cloths and clean up every speck of dust before we leave.
Another common concern is the cost of custom plumbing work during the swap. Since we align the new drain with your existing pipes, we minimize the need for expensive wall demolition. This keeps the project affordable and prevents unexpected surprises on your final bill.
We believe in absolute honesty, so we will tell you if your subfloor needs extra reinforcement before we lay the new base. Ensuring a rock-solid foundation prevents cracking and squeaking in the future. Doing things right the first time is our personal guarantee to you.
Ready to transform your cramped washroom into an open oasis of daily refreshment? We are standing by to visit your home and provide a detailed, no-obligation written quote. This custom plan shows you exactly what is possible for your specific space and budget.
Do not spend another day climbing over that high tub wall and risking a nasty fall. Let our friendly local team handle the hard work while you sit back and plan your new layout. Request your free estimate now to schedule your free estimate and take the first step toward a safer home.
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Warren City repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Gregg County; the statewide picture lives on Texas; the wider region is the South; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote