Our Tool crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Henderson County within days.
Written quote at no cost, one callback, no chasing afterwards.
Maybe you feel tired of stepping over that high porcelain barrier every single morning just to wash your hair. This daily struggle can turn your morning routine into a dangerous balancing act. Luckily, we can swap that unused basin for a spacious, modern walk-in option that fits your daily life much better.
Indeed, making this smart change will immediately give your bathroom a much larger feel. You will get more room to move around without bumping your elbows. Best of all, we offer a completely free estimate to help you plan this upgrade without any stress.
Our friendly local team loves helping homeowners update their older homes with modern features. We take care of all the heavy lifting and plumbing adjustments. You just need to choose your favorite style and watch your bathroom transform.
First of all, safety should always come first in your home. Stepping over a wet, slippery ledge measuring fifteen inches high is a recipe for a bad fall. By removing that tall obstacle, you create a seamless entry point that keeps your feet firmly on the ground.
Besides the obvious safety benefits, you will save a lot of cleanup time. Old basins have a habit of collecting soap scum and mildew in hard-to-reach corners. A modern, flat-pan setup with sleek wall panels allows you to wipe everything clean in just seconds.
On top of that, this upgrade instantly boosts the overall value of your property. Most modern buyers do not want multiple dusty tubs that they will never actually use. They prefer a quick, efficient place to wash up that looks like a high-end spa.
To begin with, we always protect your floors and walls before we touch a single tool. Our crew carefully breaks down the old cast iron or acrylic unit. We make sure to dispose of all the heavy debris so you do not have to worry about the mess.
Next, we inspect the hidden wooden framing behind your walls for any signs of water damage. This crucial step prevents mold from growing behind your gorgeous new system. If we find soft wood, we replace it right away to ensure your home stays strong.
After repairing the studs, we run the new plumbing lines and install a heavy-duty shower pan. This base must sit perfectly level to prevent leaks from damaging your subfloor. Finally, we install your choice of beautiful, water-resistant wall surrounds.
| Project Phase | What We Do | Your Concrete Benefit |
|---|---|---|
| Demolition | Careful removal of the old fixture and cleanup. | No mess left behind for you to clean. |
| Plumbing Prep | Moving the drain and installing new valves. | Perfect water flow without any leaks. |
| Wall Paneling | Sealing high-quality waterproof materials. | A beautiful look that never needs scrubbing. |
Now, you get to make the fun decisions about your new space. You can choose from a wide variety of wall patterns that mimic expensive natural stone. These materials give you a touch of class without the high cost or the annoying grout lines.
Additionally, we can install built-in seating to make your daily wash much more relaxing. This feature provides a cozy spot to rest your feet while you enjoy the warm water. It adds a level of luxury that makes your bathroom feel like a private retreat.
Which means you also get to select the perfect fixtures to match your decor. From brushed nickel to matte black handles, the choices are completely yours. We will help you find the options that work best for your budget and lifestyle.
Living in this lovely lakeside community means dealing with unique local water conditions. The minerals in our water can easily ruin cheap fixtures over time. Because of this, we only use top-grade materials that resist mineral buildup and hard water stains.
Our small town of about 2,227 residents appreciates hard work and honest pricing. With a local median household income of around $43,750, we know that every dollar you invest in your home must count. We promise to deliver top-tier results that fit your budget perfectly.
Whether you live near the water or closer to the highway, we serve your entire neighborhood. We know the local building codes inside and out, so your project will always be fully compliant. You can trust our crew to respect your home and your time.
Fortunately, we can complete most of these transformations in just a couple of days. We prepare everything ahead of time so we do not waste a single minute in your home. This speed minimizes the disruption to your daily routine.
This lets you get back to your normal life without weeks of dusty construction. We work quickly but we never cut corners on quality. Your satisfaction is our main goal from start to finish.
Actually, having at least one walk-in option is highly desirable for modern home buyers. As long as you keep one traditional basin in your other bathroom, your value will likely rise. Most people prefer the daily convenience of a fast, easy wash.
This means you get the best of both worlds for your family. You enjoy a safer, more open space today while protecting your long-term equity. It is a smart win-win situation for any local homeowner.
Now, the best way to start this exciting project is to have us look at your space. We will drive right out to your property in this beautiful pocket of Texas to inspect your layout. Our team will measure your current setup and discuss your vision.
This face-to-face visit allows us to give you an incredibly accurate quote. We do not believe in hidden fees or surprise costs at the end of the job. You will know exactly what to expect before we ever start working.
So, do not spend another day struggling with an outdated, hard-to-clean basin. Reach out to us today to request your completely free, no-obligation estimate. Let us help you create the beautiful, open space that you deserve to enjoy every single day.
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Tool repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Henderson County; the statewide picture lives on Texas; the wider region is the South; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote