Our Spaulding crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Hughes County within days.
Written quote at no cost, one callback, no chasing afterwards.
Getting into a slippery, high-walled basin every single morning can feel like climbing a small mountain.
This common frustration is why so many homeowners now choose to swap out their old, unused soaking basins for sleek, low-barrier walk-in stalls.
Our local team of experienced installers specializes in making this exact bathroom transformation fast and completely stress-free.
When you make this change, you immediately reclaim your bathroom space and make your daily routine much safer.
No more awkward stepping maneuvers over a high ledge are needed to get clean.
Instead, you get a beautiful, spacious area that fits your lifestyle perfectly.
If you are ready to modernize your home, we are here to help you take that first step.
By requesting a free on-site estimate today, you can find out exactly what it takes to upgrade your layout.
We will visit your home, measure your current setup, and explain how we can turn your old basin into a gorgeous walk-in stall.
Many older homes feature deep washing basins that nobody actually uses for soaking anymore.
These bulky fixtures take up a massive amount of floor space while offering very little practical value.
By removing them, you open up the room and create a much more functional layout.
Safety is another huge factor that drives this popular home improvement decision.
Stepping over a high acrylic or cast-iron ledge on a wet floor is a recipe for a nasty slip.
A low-threshold entry eliminates this danger entirely, which gives you absolute peace of mind every day.
On top of safety, cleaning becomes a total breeze after this swap.
Modern wall surrounds lack the deep grout lines of old tile, so you will spend far less time scrubbing on your hands and knees.
This means you get a gorgeous, low-maintenance wash space that stays sparkling clean with minimal effort.
Every home is unique, which means the physical process of removing an old basin requires careful planning.
First, our skilled crew protects your floors and carefully demolishes the outdated fixture.
We then inspect the underlying wood framing and plumbing to ensure everything is dry and structurally sound.
Once we clear the old unit, we reroute the drain lines to accommodate the new center-drain layout.
This step is crucial because waste lines for deep basins are positioned differently than those for walk-in stalls.
After the plumbing is secure, we install a heavy-duty, leak-proof pan as the foundation of your new setup.
Finally, we install your choice of waterproof wall panels, modern fixtures, and safety accessories.
We seal every joint with high-grade silicone to guarantee a lifetime of watertight performance.
The entire transformation usually takes just a couple of days, so your home life is barely disrupted.
| Feature | Old Deep Basin | Modern Walk-In Stall |
|---|---|---|
| Entry Height | 14 to 18 inches | 3 to 5 inches |
| Floor Space Usage | Bulky and restrictive | Open and spacious |
| Cleaning Effort | High (grout and corners) | Low (smooth panels) |
| Safety Rating | Risky and slippery | Very safe and accessible |
Your new wash area should reflect your personal taste while meeting your daily physical needs.
You can choose from a wide variety of wall patterns, including realistic faux stone, classic subway tile, or clean solid colors.
These choices let you match the existing decor of your home perfectly without spending a fortune.
Adding convenient accessories is another great way to customize your new setup.
We can install built-in corner caddies, sturdy grab bars, or even a comfortable fold-down bench seat.
These smart features ensure your daily wash routine is as relaxing and convenient as possible.
Furthermore, the choice of showerhead can completely change your morning routine.
From rain-style overhead fixtures to flexible handheld sprayers, the options are virtually endless.
You get to design a custom setup that works exactly the way you want it to.
Upgrading your bathroom is not just about personal enjoyment, as it also boosts your property value.
Most modern homebuyers prefer a large, walk-in stall over an outdated, unused soaking tub in the main bathroom.
This means you will likely see a great return on your investment if you ever decide to sell.
To help you plan this project, we have gathered some local demographic data for Spaulding, Oklahoma, which is located in Hughes County.
This quiet community has a population of about 134 residents, with a median household income of $28,125.
Homeowners in the local ZIP codes understand the value of making smart, affordable upgrades to their properties.
We believe that high-quality home renovations should be accessible to everyone in our community.
Our team works hard to keep costs reasonable while delivering top-tier craftsmanship on every single project.
We treat your home with the utmost respect, working quickly and cleaning up thoroughly when we finish.
Removing a heavy cast-iron or steel basin is a tough job that requires specialized tools and expertise.
Our team has the muscle and experience to extract these heavy fixtures without damaging your existing walls or floors.
We haul away all the old debris, saving you a trip to the local landfill.
Once the old unit is gone, we focus our attention on the vital plumbing connections behind the wall.
We replace outdated copper or galvanized pipes with modern, flexible PEX piping to prevent future leaks.
This ensures your new setup operates flawlessly for decades without any hidden water damage.
We also install pressure-balancing valves to protect you from sudden temperature drops when someone else runs water.
This technology keeps your water temperature stable and safe, preventing accidental scalds.
Every detail of the plumbing is handled with absolute precision to guarantee your long-term satisfaction.
Now is the perfect time to stop struggling with an outdated, inconvenient bathroom layout.
Our friendly local team is ready to help you design a beautiful, accessible space that you will love using.
We make the entire process easy, from the initial design consultation to the final cleanup.
To get started, simply reach out to us to request your completely free, no-obligation project estimate.
We will visit your home, inspect your current bathroom, and provide a detailed, honest quote.
Let us help you transform your daily routine with a gorgeous, modern walk-in upgrade that fits your budget.
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Spaulding repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Hughes County; the statewide picture lives on Oklahoma; the wider region is the South; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote