Our Rimrock crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Yavapai County within days.
Written quote at no cost, one callback, no chasing afterwards.
Maybe you are tired of stepping over that giant, slippery wall every single morning just to wash your hair. Truly, clambering into a high-walled basin feels like a daily obstacle course that nobody really asked for. This is why swapping that unused, water-wasting basin for a sleek, walk-in washing space makes total sense for your daily routine.
Consequently, you will gain a much safer setup that actually fits your modern lifestyle. Beyond that, it opens up your whole bathroom and makes the entire space look twice as big. Our local team visits homes all over Yavapai County to help folks realize this exact home improvement dream.
Naturally, we want to help you make this happen without any stress. By requesting a free project estimate today, you can start planning a setup that keeps you safe and adds serious value to your property. Let us take a look at why this simple swap is the ultimate upgrade for your home.
First of all, think about how much water you actually waste filling up a giant basin. Most of us just do not have the time for a long soak anymore because our schedules are crazy. Because of this, that big acrylic or cast-iron monster just sits there collecting dust and soap scum.
Additionally, cleaning those high walls requires you to get down on your knees and scrub like crazy. That chore is a total pain for your back and knees. By switching to a low-threshold basin with beautiful wall panels, you wipe down the surfaces in seconds.
Specifically, we can customize your new setup with built-in seating, grab bars, and recessed shelves. These smart additions mean you can store your shampoos easily and wash while sitting down if you want to. Here is a quick comparison of what you get when you make the switch.
| Feature | Old High-Walled Basin | New Walk-In Setup |
|---|---|---|
| Step-In Height | 15 to 20 inches | 3 to 5 inches |
| Required Cleaning Time | High maintenance | Quick wipe down |
| Overall Safety Level | Slippery and risky | Very secure and stable |
So, how does this process actually work when you hire us? Well, we start by measuring your existing footprint to see exactly what we are working with. Amazingly, we can usually fit the new walk-in pan right where your old fixture used to sit.
Which means you do not have to worry about tearing up all your plumbing or moving pipes around. We hook up to your current drain system, which saves you a ton of cash on labor. On top of that, we use high-quality, non-porous materials that resist mold and mildew growth.
This lets you enjoy a clean, sparkling area without using harsh chemical cleaners every weekend. Furthermore, you get to choose from a massive variety of colors, tile patterns, and hardware finishes. You can go for a modern slate look or a classic marble style without the heavy price tag of real stone.
Actually, living in a beautiful desert community means we have to deal with unique water conditions. The hard water around here can really do a number on old fixtures, leaving ugly white mineral deposits everywhere. For this reason, we install durable acrylic surfaces that fight off hard water stains and stay looking brand new.
If you live in Rimrock, Arizona, you know how important it is to have a home that feels like a relaxing oasis. With a local population of about 3,344 people, this tight-knit community deserves top-notch service from friendly neighbors who care. Whether your home is near the creek or up on the mesa, we know the local building codes inside and out.
Importantly, our team respects your property and keeps the job site clean from start to finish. We realize that having construction in your home is disruptive, so we work fast to get your water running again. Many of our custom swaps in the 86335 ZIP code area take just a couple of days to complete.
Let us be honest, slipping in the bathroom is one of the most common ways people get hurt at home. By lowering the entry threshold to just a few inches, you eliminate that dangerous tripping hazard instantly. This simple change lets older family members stay independent in their homes much longer.
Similarly, kids and teenagers find it much easier to use, which means fewer puddles on your floorboards. We can even install textured floors that prevent slips when the surface is soapy and wet. Your peace of mind is worth every penny, especially when it comes to protecting your loved ones.
Now, you might wonder if removing a bath hurts your home resale value. While having at least one soaking option in the house is good, most buyers actually prefer a spacious walk-in area in the master suite. This upgrade gives your bathroom a luxurious, spa-like atmosphere that grabs the attention of potential buyers.
Given that the median household income in this area is growing, people want modern amenities that look fantastic. A dingy, outdated basin can make your whole house feel old and neglected. Upgrading this single area makes your entire master suite feel like a high-end retreat.
When you contact us, we do not just send you some generic price sheet because every home is different. Instead, we come out to your place to look at your plumbing, discuss your style preferences, and take exact measurements. This ensures you get an accurate, honest quote with absolutely no hidden fees or surprises down the road.
During our visit, we will show you physical samples of our top-tier materials so you can feel the quality. You can ask us all your questions about drain placement, wall surrounds, and accessory options. We want you to feel completely confident and informed before we ever pick up a tool.
To make things even better, our quotes are entirely free and carry no obligation whatsoever. We believe in earning your business through honesty, great customer service, and unmatched local craftsmanship. Reach out to us today to schedule your walk-through and take the first step toward a gorgeous, accessible new space!
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Rimrock repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Yavapai County; the statewide picture lives on Arizona; the wider region is the West; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote