Our Reid crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Washington County within days.
Written quote at no cost, one callback, no chasing afterwards.
Maybe you feel tired of stepping over that high, slippery ledge every single morning just to wash off the sleep. This daily obstacle race gets old pretty fast, especially when you just want a quick, breezy wash before heading out to work. Happily, a local team of home remodeling pros can swap that outdated, deep basin for a sleek, low-profile basin enclosure that fits your busy life much better.
By making this simple change, you instantly open up your layout and make the whole room feel twice as large. Your old wash station probably collects dust and soap scum in hard-to-reach corners because nobody has time for a long soak anymore. This modern swap gives you back your floor space and makes your daily routine feel like a breeze.
Fortunately, you do not have to figure out the plumbing layout or the heavy lifting all by yourself. Our friendly local crew drives right to your home to look at your setup and give you a completely free estimate. This means you get honest, face-to-face advice without spending a single dime upfront.
| Old Setup Issues | New Setup Benefits |
|---|---|
| High step-over hazard | Low-threshold easy entry |
| Hard to scrub corners | Non-porous easy-wipe walls |
| Cramped standing area | Spacious shoulder room |
Think about how much safer your home becomes when you eliminate the risk of slipping while climbing out of a deep pool. Many homeowners worry about guest safety or their own long-term mobility, which makes this upgrade a smart move for the future. You get peace of mind knowing that everyone in the house can wash up safely.
Besides the safety aspect, you will save a massive amount of cleaning time every single week. Old porcelain and grout lines love to harbor stubborn mold, whereas new acrylic and solid surfaces resist buildup naturally. This change lets you spend your weekends relaxing instead of scrubbing tile joints with an old toothbrush.
On top of that, your water bills might actually decrease when you stop filling a giant basin and switch to a high-efficiency spray. It feels great to watch your utility costs go down while actually improving your daily comfort. We love showing people how much they can save with a quick design consultation at their property.
Because our small community sits quietly within Washington County, we understand the specific home styles and water conditions of the local area. With a tiny population of just forty-four residents, every single home project we do around here deserves personal care and attention. We treat your house with the same respect we show to our very own families.
Whether you live in a cozy historic house or a more modern property, we know how to handle the unique plumbing quirks of local ZIP codes. Our team knows how to navigate old pipe materials and uneven subfloors without causing unnecessary delays. This local knowledge guarantees that your project stays on track and within budget.
Since the median household income in this part of Maryland reflects hardworking families who value real quality, we make sure our prices stay fair and transparent. You will never have to deal with hidden fees or surprise upcharges when you work with us. We lay out every detail clearly in your initial assessment so you can make an informed decision.
First, our crew carefully disconnects your old plumbing fixtures and removes the bulky cast iron or steel tub without damaging your walls. This step requires a lot of muscle and patience, but we protect your floors with heavy drop cloths the entire time. You do not have to worry about a big mess left behind in your hallway.
After the old unit is out, we inspect the wood framing underneath for any hidden water damage or rot. Fixing these issues early prevents mold from growing behind your gorgeous new walls later on down the road. This thorough inspection ensures your new setup lasts for decades without any structural issues.
Next, we install a heavy-duty, leak-proof pan directly onto your subfloor to create a solid foundation. This specialized base directs every drop of water straight down the drain where it belongs. We then secure beautiful, waterproof wall surrounds that match your personal style perfectly.
Once the walls are up, we can add handy features like built-in seating, sturdy grab bars, or corner shampoo shelves. These custom touches make your daily wash feel incredibly convenient and tailored to your specific needs. You get to choose the exact colors and patterns that make your eyes happy.
Finally, we hook up your brand-new showerhead, mixing valves, and sleek glass doors for a polished look. We test every single connection under pressure to ensure there are absolutely zero leaks behind your walls. This meticulous testing gives you complete confidence the very first time you turn on the water.
Once we clean up every speck of dust, we hand over the keys to your brand-new personal oasis. You will amaze your friends and family with how much brighter and more spacious your bathroom looks. This simple home upgrade truly transforms the way you feel about your living space.
If you feel ready to say goodbye to your awkward, high-walled tub, our team is ready to help you take the next step. We make the entire process stress-free by coming directly to your home to take precise measurements. This personalized visit ensures that your new setup fits like a glove.
During our visit, we will listen to your ideas and show you all the beautiful design options available for your budget. You get a clear, written estimate that details the exact cost of the project from start to finish. There is absolutely no pressure or obligation to buy anything during this friendly consultation.
Do not wait until a slip or fall forces you to make a hasty decision under stressful circumstances. Take control of your home remodeling goals today by reaching out to our local team. Simply request your free quote now, and let us help you build the beautiful, accessible washroom you deserve!
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Reid repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Washington County; the statewide picture lives on Maryland; the wider region is the South.
One three-day job stands between this bathroom and its best fixture.
Get my free quote