Our Jones Creek crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Brazoria County within days.
Written quote at no cost, one callback, no chasing afterwards.
Maybe you are tired of tripping over that high porcelain ledge every single morning. Because of this, swapping your old deep soaking tub for a modern walk-in stall makes total sense. This smart update instantly opens up your room and gives you a much safer way to wash up.
Actually, many homeowners in this cozy Brazoria County community are making the switch right now to save precious space. By choosing this popular upgrade, you get a clean layout that fits your daily routine much better. Plus, you can finally stop scrubbing those hard-to-reach corners of an old basin you never even fill up with water.
If you want to make your daily routine easier, we are ready to visit your home and give you a free estimate. Our friendly local team will look at your current plumbing setup and explain how we can remodel it without any hassle. This means you get a clear plan and a exact price quote without spending a single penny upfront.
When you replace that bulky basin with a spacious walk-in stall, you immediately gain a lot of physical freedom. Indeed, traditional tubs take up a massive amount of floor space while offering very little actual standing room. By removing that old barrier, you create a open area where you can move around without feeling squeezed.
On top of that, your safety levels go up the moment you remove the need to balance on one wet foot. This lets you step directly onto a low-profile slip-resistant pan instead of climbing over a steep wall. For anyone worried about slips, this single change brings immense peace of mind and keeps you independent in your own home.
To give you a better idea of what to expect, we put together a quick comparison table below.
| Feature | Old High-Walled Basin | New Walk-In Stall |
|---|---|---|
| Step-in Height | Usually 14 to 18 inches | Often less than 3 inches |
| Usable Area | Cramped and narrow | Wide and spacious |
| Maintenance | Hard to scrub corners | Easy wipe-down surfaces |
First, we come out to your house in Jones Creek, Texas to inspect your existing bathroom configuration. Since this lovely coastal bend area near the Gulf has unique local plumbing characteristics, we make sure your drainage is ready for the upgrade. This careful check prevents any unexpected water back-ups or leaks down the road.
After that, we carefully remove the old heavy cast iron or fiberglass structure without damaging your surrounding walls. Next, our crew installs a brand new waterproof pan and runs the necessary plumbing lines to ensure perfect drainage. Finally, we finish the walls with beautiful, water-resistant panels or custom tile work that matches your personal taste.
Because we live and work nearby, we understand the local building codes and permits required for this type of home improvement. Which means you do not have to worry about paperwork or inspections because we handle all those stressful details for you. You can just sit back and watch your old bathroom transform into a modern oasis.
Naturally, you want your new washing space to look beautiful and stay easy to clean for many years. Acrylic wall systems are incredibly popular because they do not have grout lines that trap nasty mold and mildew. This lets you clean the entire surface with a simple squeegee and mild soap instead of harsh chemicals.
Alternatively, custom tile offers a timeless look that can match any style from rustic to ultra-modern. While tile requires a bit more maintenance, it allows for unique patterns and built-in recessed niches for your shampoo bottles. Whichever path you choose, we ensure the backing is completely waterproof so moisture never seeps into your drywall.
Once the main structure is ready, you get to choose the hardware that controls your water flow. A sliding glass door with a trackless design prevents water from splashing onto your floor while keeping the look sleek. This lets light pass through the room, which makes even a tiny bathroom feel twice as large.
In addition, installing a handheld showerhead gives you incredible flexibility when rinsing off or cleaning the stall itself. This lets you direct the water exactly where you need it without twisting your body into uncomfortable positions. We can also install comfortable seating and sturdy grab bars that blend beautifully with your chosen metal finishes.
Understandably, you might worry about the price of such a major change to your home layout. However, this specific renovation offers one of the highest returns on investment for residential properties today. Homebuyers actively look for modern walk-in stalls because they prefer them over dusty, unused bathing wells.
Furthermore, we work hard to keep our pricing highly competitive and transparent for all our neighbors in the region. With a local median household income of around $46,000, we know that every hard-earned dollar needs to be spent wisely. That is why we provide detailed estimates that break down every single cost before any work begins.
When you consider the daily convenience and the added safety, this project easily pays for itself in sheer usability. You will no longer dread your morning routine or worry about slipping on a wet porcelain edge. Instead, you get a bright, open space that feels like a private spa right in your own home.
Now is the perfect time to stop putting off this essential upgrade to your living space. Our team is ready to drive out to your property, answer your questions, and design the perfect solution. This lets you explore all your options with absolutely zero obligation or pressure.
Simply contact us today to schedule your convenient on-site consultation with our friendly remodeling crew. We will measure your space, show you beautiful material samples, and provide a written quote that fits your budget. Let us help you create a safer, more open, and truly beautiful bathroom that you will love using every single day.
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Jones Creek repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Brazoria County; the statewide picture lives on Texas; the wider region is the South; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote