Our Groveville crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Mercer County within days.
Written quote at no cost, one callback, no chasing afterwards.
Maybe you are tired of stepping over that high, dangerous wall every single morning just to wash off the daily grime. Because of this everyday struggle, many local homeowners decide to swap out their deep, unused basins for a modern, walk-in option. Transforming your washing space not only saves your knees but also breathes fresh life into a tired room.
Suddenly, you have a spacious area where you can actually move around. Which means you can stop worrying about slips and enjoy your morning routine again. Our team loves helping folks make this transition without any of the typical remodeling headaches.
If you live in our lovely little corner of Mercer County with its 2,234 friendly neighbors, you know how cozy these local homes are. However, many older homes around here still have outdated setups that do not fit a fast-paced lifestyle. We are ready to visit your house and give you a completely free estimate to update your setup.
Let us be completely honest about how we use our washrooms today. First of all, almost nobody has the time to sit and soak in a deep basin for an hour anymore. By replacing that bulky barrier with a low-threshold basin, you gain immediate convenience and peace of mind.
This simple swap improves safety for everyone in your household. For instance, kids and grandparents alike can step inside without performing a balancing act. You get to enjoy maximum utility and a sense of open freedom in a room that used to feel cramped.
To give you a better idea of how these two setups compare, we put together a quick breakdown of what you actually get from this upgrade.
| Feature | Old Deep Basin Setup | Modern Walk-In Setup |
|---|---|---|
| Step-In Height | High wall (usually 15-20 inches) | Very low threshold (usually 1-3 inches) |
| Floor Space | Narrow and curved bottom | Wide, flat, slip-resistant surface |
| Cleaning Effort | Hard to reach corners and grime rings | Non-porous walls that wipe down easily |
| Water Usage | Demands gallons of hot water to fill | Efficient drainage with modern fixtures |
Now, you might wonder how we actually pull off this magic trick in your home. Actually, the process is pretty straightforward when you have the right hands on deck. We start by carefully removing the old cast iron or acrylic beast without damaging your surrounding walls.
Once the old unit is out, we inspect the underlying pipes for any hidden water damage or mold. This step ensures your new setup sits on a solid, dry foundation. After that, we install a custom pan and beautiful, waterproof wall panels that look amazing.
On top of that, we can add built-in shelves, sturdy grab bars, and even a comfortable bench seat. Consequently, your daily rinse becomes a luxurious experience rather than a chore. We complete most of these jobs in just a couple of days so your life is barely disrupted.
Think about the financial side of things for a second. Since the median household income around these parts sits at $74,750, local homeowners appreciate smart investments that pay off later. A clean, modern walk-in stall is one of the most requested features for home buyers today.
Many buyers will walk away from a house if the master bathroom feels like a time capsule. By making this change now, you get to enjoy the upgrade yourself while boosting your equity. It is a rare win-win situation for your daily routine and your wallet.
Whether your home sits in the 08620 area or nearby, we know the local building codes inside and out. This means your project is done safely, legally, and to the highest standards. We handle the permit headaches so you can sit back and watch the magic happen.
When it comes to materials, you have some great options to fit your personal style. For example, high-quality acrylic surrounds offer a seamless look that prevents mold from growing in grout lines. This lets you spend your weekends relaxing instead of scrubbing tile joints with a toothbrush.
If you prefer a more traditional look, modern solid surfaces offer the appearance of stone without the heavy maintenance. Which means you get the aesthetic appeal you want with none of the sealing hassles. We bring samples directly to your door so you can see them in your own lighting.
Our local team takes pride in matching the unique character of our historic state. We want your new washing area to feel like it always belonged there. During your free consultation, we will discuss every material option to find the perfect fit for your budget.
Usually, we can complete the entire tear-out and installation in about two to three days. This fast turnaround keeps your household running smoothly without long-term disruptions. We clean up our mess completely before we leave your home.
Yes, we usually keep the main drain and water lines in the exact same location to save you money. This clever approach avoids costly behind-the-wall plumbing relocations. It keeps the project affordable while still giving you a brand-new experience.
Absolutely, because the modern materials we use do not have deep grout lines where soap scum hides. A quick wipe with a damp cloth and mild soap is usually all it takes to keep it sparkling. You will save hours of hard labor every single month.
Do not let another day pass by while struggling with an outdated, unsafe washroom setup. Instead, take a moment to imagine stepping into a bright, open, and beautiful stall every morning. You deserve a space that makes you feel relaxed and safe in your own home.
We invite you to reach out to us today for your completely free, no-obligation estimate. Our friendly team will visit your home, measure your space, and give you an honest price. Let us help you turn your old washroom into your favorite room in the house.
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Groveville repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Mercer County; the statewide picture lives on New Jersey; the wider region is the Northeast; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote