Our Fenton crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Saint Louis County within days.
Written quote at no cost, one callback, no chasing afterwards.
Getting stuck in a daily routine that feels outdated can really ruin your morning mood. Maybe you are tired of climbing over a high porcelain barrier just to wash your hair every single day. If that sounds like your current situation, swapping that old basin for a sleek walk-in stall might be the smartest move you make this year.
Fortunately, making this change instantly upgrades your daily routine by saving you time and energy. You get to step directly into a spacious area without any awkward balancing acts. It is all about making your life easier while adding a fresh look to your home.
Naturally, our local crew is ready to visit your house and provide a completely free written estimate for this exact project. We believe in honest pricing and zero pressure so you can make the right choice for your family. Let us help you turn that cramped bathing area into something you actually enjoy using.
First of all, let us talk about the obvious safety hazard of wet slip surfaces. Climbing over a high ledge on a slick floor is basically an accident waiting to happen, especially if your knees are not what they used to be. By removing that tall obstacle, you create a much safer environment for everyone in the household.
In addition to safety, think about how much easier it is to clean a flat, modern pan compared to a deep, curved basin. You will no longer have to bend down and scrub those hard-to-reach corners that collect soap scum and grime. This change means you spend less time on your knees scrubbing and more time relaxing.
To give you a better idea of how these two options stack up, let us look at a quick comparison of their daily benefits.
| Feature | Old Deep Basin | New Walk-In Stall |
|---|---|---|
| Entry Height | High step-over (15-20 inches) | Low threshold (3-5 inches) |
| Cleaning Effort | High bending and scrubbing | Easy wipe-down surfaces |
| Visual Space | Makes the room feel smaller | Opens up the entire room |
| Water Usage | High volume for filling | Efficient drainage flow |
As you can see, the benefits of modernizing your layout go far beyond just aesthetics. It actually changes the way you interact with your home on a daily basis. You deserve a setup that works with your lifestyle instead of against it.
When you decide to take this step, you are not just getting a generic replacement insert. Instead, you get to customize the walls, the hardware, and the seating options to fit your personal style. We offer everything from sleek acrylic panels that look like expensive stone to custom tile work that adds a premium feel.
Besides the look of the walls, you can also add built-in benches or sturdy grab bars for extra support. These features do not have to look clinical or boring either. We install modern, stylish hardware that looks great while keeping you safe and secure.
On top of those options, you can choose between sliding glass doors or an open wet-room design. This flexibility lets you design a space that fits the exact layout of your existing bathroom perfectly. Our team will walk you through every option during your free home consultation.
Many homeowners worry that their entire house will be a chaotic construction zone for weeks on end. Thankfully, our experienced team has refined this process down to a science. We protect your floors, contain the dust, and usually finish the heavy lifting much faster than you would expect.
First, we carefully remove the old cast iron or steel basin without damaging your surrounding walls. This step requires a lot of muscle and the right tools to avoid any plumbing mishaps. We inspect the subfloor underneath to ensure there is no hidden water damage or rot before we proceed.
Next, we update the pipe connections to match the new drain location and install the secure base. After that, we seal the walls with premium waterproof barriers to prevent any future mold issues. Finally, we install your chosen wall panels, fixtures, and doors with absolute precision.
Living in Saint Louis County means we experience all four seasons, which can sometimes bring damp air and moisture challenges into our homes. Upgrading your wet area with modern, mold-resistant materials keeps your indoor air cleaner and healthier. It is a solid investment in the longevity of your property.
Speaking of investments, did you know that many buyers prefer a spacious walk-in setup over a dusty old soaking basin? In a busy area like Fenton, Missouri, where the median household income is about $92,544, people value convenience and modern design. If you live in the 63026 or 63099 ZIP codes, this upgrade can seriously boost your home appeal.
Even if you are not planning to sell anytime soon, you get to enjoy the luxurious feel of a custom remodel every single day. With a local population of around 4,034 residents, we treat every customer like our neighbor. We take pride in helping our community members improve their living spaces one home at a time.
Ultimately, your home should be a place where you feel completely comfortable and relaxed. If your current setup feels more like a chore than a retreat, it is time to make a positive change. You do not have to live with an outdated, hard-to-clean layout anymore.
By choosing our local team, you get friendly service, top-tier craftsmanship, and a gorgeous finished product. We handle all the permits, plumbing, and heavy lifting so you do not have to stress about a single detail. We stand behind our work and guarantee your satisfaction from start to finish.
Now is the perfect time to take action and get the beautiful, accessible washroom you have always wanted. Reach out to us today to request your free in-home estimate and design consultation. Let us show you how easy and affordable it is to transform your space into something truly wonderful.
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Fenton repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Saint Louis County; the statewide picture lives on Missouri; the wider region is the Midwest; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote